How to set the temperature on a Pozis Paracels refrigerator: a detailed guide with expert advice

Refrigerators Pozis Paracels are known for their reliability and energy efficiency, but even the most modern equipment requires proper configuration. Incorrectly selected temperature conditions can lead to food spoilage, increased energy consumption, or even compressor failure. In this article, we will look at how to accurately adjust the temperature on models Paracels with mechanical and electronic control, what values ​​are considered optimal for different types of products, and what to do if the refrigerator does not maintain the set mode.

A feature of the line Pozis Paracels is an adaptive cooling system that automatically adjusts the operation of the compressor depending on external conditions. However, this does not mean that you can leave the factory settings as is. For example, in hot summers or when the door is opened frequently, manual adjustment will be required. We will also tell you how to reset the settings to factory settings if you experimented with the modes and got an unexpected result.

It is important to note that instructions may vary slightly depending on the model year and modification (for example, Paracels RK-101 vs Paracels RK-140W). If your refrigerator is equipped with a display with touch controls, the adjustment algorithm will be simpler than for models with mechanical controls. But in any case, the process will take no more than 5 minutes.

Optimal temperature conditions for Pozis Paracels

The manufacturer recommends maintaining a temperature of refrigerator compartment from +2°C to +5°Cand from -18°C down to -24°C. However, these values may vary depending on: freezer compartment — from -18°C to -24°C. However, these values ​​may vary depending on:

• 📦 Type stored products (meat, dairy products, vegetables require different conditions)
• 🌡️ Room temperatures (in hot weather the compressor works more intensely)
• ⚡ Door opening frequency (frequent use increases the load)
• ❄️ The presence of the No Frost function (models without it require manual defrosting)

For example, for long-term storage of meat and fish in the freezer it is optimal -20°C, and for frozen vegetables it is sufficient -18°C. In the refrigerator compartment The warmest zones are the door and upper shelves (up to +5°C), and the coldest are the lower shelves above the vegetable boxes (up to +2°C). This is due to the natural circulation of cold air.

⚠️ Attention: If your refrigerator Pozis Paracels is set to Super Cool or Super Freeze, it automatically lowers the temperature 2-3 degrees below the set one for 6-12 hours. Do not forget to turn it off after loading a large number of products, otherwise energy consumption will increase by 15–20%.

Temperature adjustment on models with mechanical controls

Refrigerators Pozis Paracels with mechanical regulators (for example, series RK-101 or RK-120) are equipped with rotary knobs inside the cameras. They usually have a scale from 1 (warmest) to 7 (coldest). The manufacturer recommends installing:

• 🔄 For the refrigerator compartment: position 3–4 (corresponds to +4°C)
• ❄️ For the freezer: position 5–6 (corresponds -18°C...-20°C)

To change the settings:

1. Open the refrigerator or freezer door.
2. Find the regulator - it is usually located on the right wall or ceiling of the chamber.
3. Turn the knob clockwise arrow for lower temperature, against - to increase.
4. Wait 6-8 hours until the temperature stabilizes (the compressor turns on with a delay).

Make sure the door closes tightly|Check that it does not are the shelves overloaded (this interferes with air circulation)|Use a thermometer for an accurate measurement|Do not place the refrigerator near heat sources (radiator, stove)

-->

If after setting the temperature is still not as expected, check:

• 🔌 Voltage on the network (at low voltage the compressor does not work efficiently)
• 🧊 The thickness of the ice in the freezer (if more than 5 mm, defrosting is required)
• 🚪 Door seals (when worn, the cold comes out)

⚠️ Attention: On models with with one compressor (for example Paracels RK-101M), the refrigerator compartment regulator indirectly affects the freezer. If you turn it up to maximum, the freezer can cool down to -25°C, which will increase the load on the system. It is optimal to keep the main regulator on 3–4, and adjust the freezer separately, if this is provided for by the design.

Adjusting the temperature on models with electronic control

Refrigerators Pozis Paracels with display (series RK-140W, RK-160N and newer) allow you to set the temperature with an accuracy of 1°C. Control is carried out via touch buttons or a rotary encoder. Setting algorithm:

1. Press the button Menu or Settings (depending on the model).
2. Select section Temperature or Modes.
3. Use the buttons +/– or the rotary encoder to set values for:
   • Refrigerator compartment (usually displayed as Fridge)
   • Freezer compartment (usually Freezer)

Confirm the settings with the button OK or automatically (after 5 seconds of inactivity).

The display will show the current temperature inside the chambers. If the indicator next to the numbers is lit Super, then the intensive cooling mode is activated. To turn it off, hold the button Super Cool or Super Freeze 3 seconds.

Some models have an option Ecothat automatically optimizes the temperature to save energy. However, in hot weather (above +30°C indoors) it is better to turn it off, since the compressor may not be able to cope with the load.

How to check the accuracy of the temperature without a thermometer

If you don’t have a specialized thermometer for the refrigerator at hand, you can use improvised means:

• 🥛 Test with milk: place the carton of milk on the middle shelf. If after 12 hours it has not turned sour, the temperature is above +5°C. If a crust of ice appears on the surface, below +2°C.
• ❄️ Ice test: put ice cubes in a bag in the freezer. If after a day they stick together in a lump, the temperature is above -18°C. If the ice has become “dry” (moisture on the surface has disappeared) - below -20°C.
• 🍎 Test with apples: put the apple in the vegetable drawer. If after 3 days it becomes soft, it is too warm (+6°C and above). If it is covered with condensation, it is too humid or cold.

For accurate measurements it is better to use digital thermometer with external sensor (costs from 200 rubles). Place the sensor in a glass of water and leave it on the middle shelf of the refrigerator for 8–12 hours. In the freezer, the sensor can be placed between foods.

⚠️ Attention: If the difference between the set temperature and the actual temperature exceeds 3°C, this may indicate a malfunction of the thermostat or sensor. In models Pozis Paracels with electronic control, the sensor error is displayed on the display as a code E1 or E2. In this case, diagnostics by a service center is required.

Once a week|Only when something goes bad|Never checked|I use a smart thermometer-->

Frequent errors when setting the temperature

Even experienced users sometimes make mistakes that lead to excessive energy consumption or food spoilage. Here are the most common ones:

• 🔥 The temperature in the refrigerator compartment is too low (below +2°C): food freezes, and the compressor works without stopping, which reduces its resource.
• 🌡️ Ignoring external temperature: in hot weather (+30°C and above) you need to increase the cooling power by 1–2 division.
• ❄️ Continuous use of the mode Super Freeze: this increases energy consumption by 25-30% and loads the system.
• 🚫 Blocking of ventilation holes with food or dishes, which disrupts air circulation.

Another typical problem is uneven cooling on cameras. If ice forms in one corner of the refrigerator, and food spoils in the other, the reasons may be as follows:

• Malfunction fan (in models with No Frost)
• Leakage refrigerant (refill required)
• Clogging capillary tubes (needs repair)

How to understand that the compressor is not working properly?

If the refrigerator turns on more than once every 30 minutes or works without stopping for more than 2 hours, this is a sign of a malfunction. Also pay attention to the sound: a normal compressor makes a smooth hum, not knocking or vibration In models Pozis Paracels c. with an inverter compressor, it should smoothly pick up and drop speed, and not turn on/off abruptly.

If you notice that the refrigerator has become worse in cooling, first try:

1. Defreeze it for 12–24 hours (even if the model is with No Frost).
2. Wipe the back wall and condenser from dust.
3. Check the voltage in the outlet (should be 220V ± 10%).

Reset settings to factory settings

If you experimented with the modes and the refrigerator began to work unstably, you can return the factory settings. The method depends on the type of control:

For. mechanical models:

• Turn the refrigerator and freezer regulators to the position 0 (off).
• Unplug the refrigerator for 10 minutes.
• Turn on and set the regulators to 3–4 (refrigerator compartment) and 5 (freezer compartment).

For electronic models:

1. Press and hold the button Menu (or Settings) for 10 seconds, until the display flashes.
2. Use the buttons +/– select the option Reset or Default.
3. Confirm the reset with the button OK.

After resetting the refrigerator Pozis Paracels will automatically reboot and the display will show the factory values: usually +4°C for the refrigerator compartment and -18°C for the freezer compartment. If the reset does not help and the problems persist, contact the service center.

⚠️ Attention: On models with the function Smart Control (for example Paracels RK-160N), resetting the settings also resets data about the user's preferences (for example, the frequency of opening the door). After resetting, the refrigerator will need 2-3 days to again “learn” to optimize operation according to your habits.

Energy-saving tips for Pozis Paracels

Refrigerators Pozis Paracels belong to the energy efficiency class A+ or A++, but even they can consume excess electricity if used incorrectly. Here's how to reduce costs:

• 🔌 Move the refrigerator away from the wall on. 5–10 cm for better ventilation of the compressor.
• ☀️ Avoid direct sunlight —they heat the case, causing the compressor to work longer.
• 🧊 Defrost regularly (even models with No Frost need defrosting once a year).
• 📦 Do not load the chambers by more than 70% - this disrupts air circulation.
• 🚪 Check the seals - if they have lost elasticity, the cold goes away out.

Another effective way to save money is to use night modeif it is provided in your model. In this case, from 23:00 to 7:00, the temperature in the refrigerator compartment automatically increases by 1-2°C, and the compressor operates in a gentle mode. mode. It is activated through the menu Eco → Night Mode.

If your refrigerator supports connection to the application. Pozis Smart, use it to monitor energy consumption. The application shows how much electricity is spent per day/week/month and gives recommendations for optimization.

FAQ: Frequently asked questions about setting up Pozis Paracels

Is it possible to set different temperatures on different shelves?

No, in refrigerators Pozis Paracels the temperature is regulated uniformly for the entire chamber. However, you can use zones with different natural temperatures: the lower shelves are 1-2°C colder than the top ones. For accurate control, you will need a thermometer and manual rotation of products.

Why does the freezer work, but the refrigerator does not?

This is a typical sign clogging. capillary tube or thermostat malfunction of the refrigerator. In models with one compressor, the cold first enters the freezer, and then into the refrigerator. If the circulation is disrupted, the second chamber stops cooling.

How often do you need to defrost a refrigerator with No Frost?

Even systems No Frost require defrosting once every 12 months. This is necessary to remove ice from the evaporator (it forms in. microcracks) and cleaning the drainage hole. Turn off the refrigerator, leave the doors open for 6-8 hours, then wipe the internal surfaces with a soda solution (1 tablespoon per 1 liter of water).

What to do if the refrigerator constantly works and does not turn off?

The reasons may be different:

• High room temperature (above +30°C).
• Malfunction of the thermostat or temperature sensor.
• Refrigerant leak (refill required).
• Condenser clogged with dust (rear side needs to be cleaned wall).

First, check external factors (temperature in the room, loading of products), then call a technician.

Is it possible to turn off the refrigerator at night to save money?

No, this will lead to spoilage of food and increased load on the compressor the next time it is turned on. Modern. refrigerators Pozis Paracels consume only 0.5–1 kWh per day - savings from shutdown will be minimal, and the risks are high. Instead, use the mode Eco or Holiday.