Disconnection freezer compartment in the refrigerator Atlant is a problem that owners face during seasonal use, repairs or moving. But incorrect actions can lead to compressor breakdown, freon leakage or even fire. In this article, we will look at the official methods of deactivating a freezer for different series Atlant (single-chamber, double-chamber, with system No Frost and drip defrosting), and also tell you what mistakes users most often make.
It is important to understand: the procedure differs depending on from control type (mechanical or electronic) and refrigerator design. For example, in models Atlant MXM 2835-90 and Atlant XM 4625-000 the algorithm will be different. We have collected current data from the manufacturer's instructions and recommendations from service centers so that you can shut down without risk to your equipment.
When do you need to turn off the freezer?
Deactivation of the freezer is required in several cases:
- 🏡 Seasonal use. At the dacha in winter or in a country house where you rarely visit, the freezer may sit idle unnecessarily.
- 🔧 Repair or replacement of parts. For example, if the thermostat breaks down, freon leaks, or the seal is replaced.
- 🚛 Moving or transportation. The freezer is turned off 12–24 hours before transportation to avoid damage to the compressor.
- 💰 Saving energy. If the freezer is empty, turning it off will reduce consumption by 20–30%.
However, there are situations when turning off the freezer is strictly forbidden:
- ❄️ If food is stored in the refrigerator perishable products (dairy, meat, fish) - this will upset the temperature balance.
- 🔌 If you suspect a short circuit or damage to the wiring, first fix the problem.
⚠️ Attention: In refrigerators Atlant s one compressor (for example, Atlant MX 2823) turning off the freezer automatically stops cooling the refrigerator compartment. Make sure this is acceptable in your situation.
Preparing the refrigerator to turn off the freezer
Before By deactivating the freezer compartment, follow the required steps:
Defrost the chamber and remove the ice|Remove all food|Wipe the internal surfaces with a dry cloth|Disconnect the refrigerator from the mains for 10 minutes (to reset the settings)|Check the integrity of the door seal-->
If there is ice left in the freezer, it must be removed. In models with drip system (Atlant XM 4021-000) it is enough to leave the door open for 4–6 hours. To No Frost (Atlant HM 6025-080, use the defrost mode (if available) or turn off the power for 12 hours.
Pay special attention door seal. If it is damaged, the temperature in the refrigerator compartment may rise after turning off the freezer. Checking the tightness is simple: close the door, bring a sheet of paper and try to pull it out. If the sheet comes out easily, the seal requires replacement.
Disconnecting the freezer in refrigerators Atlant with mechanical control
Mechanical models (Atlant MXM 1635, Atlant MX 2824) are controlled by rotary controls. To turn off the freezer:
- Turn the freezer temperature regulator (usually indicated by a snowflake 🏔️) to position
OFFor0. - If the regulator does not have a position
OFF, set it to the minimum mark (for example,1). - For models with one compressor turning off the freezer stops the operation of the entire refrigerator. In this case, use the button
On/Offon the rear panel (if any).
In refrigerators with two compressors (for example, Atlant DX 4208-000) the freezer turns off independently from the fridge compartment. It is enough to turn its regulator to the position OFF.
| Refrigerator model | Control type | Method of turning off the freezer |
|---|---|---|
| Atlant MXM 1701 | Mechanical | Regulator in position 0 |
| Atlant XM 4526-000 | Mechanical | Regulator for minimum level (1) |
| Atlant DX 2806-000 | Mechanical (2 compressors) | Separate freezer regulator c OFF |
⚠️ Attention: In models Atlant older than 2010, the regulators may not have a position OFF. In this case, to completely turn off the freezer, you need to remove the plug from the socket. However, this will also stop the operation of the refrigerator compartment. data-i="132">Attention:
Disconnecting the freezer in refrigerators Atlant with electronic control
Electronic models (Atlant NM 6021-080, Atlant XM 6321-031) are equipped with touch panels or buttons:
- Press the button
Freezer compartment(indicated by a snowflake ❄️). - Hold it for 3-5 seconds until
OFFor0°C. - In models with a display (Atlant XM 6025-080) appears on the display:
Settings → Modes → Freezer → Off
If the freezer does not turn off:
- 🔄 Try resetting the settings by unplugging the refrigerator for 1 minute.
- 📱 Check if is the mode activated? data-i="154">inverter compressor Super freezing (indicated by ❄️❄️). It must be disabled separately.
- 🔧 In models with inverter compressor (Atlant NM 6204-180) you may need to hold the button until a beep sounds.
What to do if the freezer does not turn off?
If after all the manipulations the freezer continues to work, the reasons may be the following:
- 🔌 Thermostat malfunctionThe device does not record the temperature change and constantly sends a signal to the device. compressor.
- 🧊 Clogged drainage system. In models with No Frost this can lead to false alarms of the sensors.
- 🔋 Problems with the control board. voltage.
- ❄️ Super Freeze mode is activated. In some models it blocks the freezer from turning off.
For diagnostics:
- Unplug the refrigerator for 10–15 minutes, then turn it on again. If the freezer starts automatically, the problem is in the electronics.
- Check whether the indicator Accident (red or yellow LED) is on. If yes, repair is required.
- Listen to the compressor: if it works non-stop, it is probably out of order start-up relay.
⚠️ Attention: If the refrigerator Atlant with electronic control does not respond button presses, do not try to disassemble the panel yourself. In models with touch control (Atlant XM 6026-080), there is a high risk of damage to the cables.
How to check the thermostat with a multimeter?
To check the thermostat:
1. Unplug the refrigerator.
2. Remove the protective cover from the thermostat (usually located inside the freezer).
3. Disconnect the wires from the terminals (take a photo of their location!).
4. Switch the multimeter to resistance test mode (200 Ohm).
5. At room temperature, the resistance between the terminals should be 0 ohms (closed). If the device shows a break, the thermostat is faulty.
How to properly turn the freezer back on?
After turning off, the freezer cannot be turned on immediately. Follow the algorithm:
- Wait at least 5–10 minutes before turning it on again. This is necessary to equalize the pressure in the system.
- For mechanical models, turn the regulator to position
2–3(medium temperature). - For electronic models, press the ❄️ button and set the temperature
-18°C. - Close the door and wait 1-2 hours until the temperature stabilizes. Do not load food right away!
If after turning on the freezer does not cool:
- 🔊 Check whether the sound of the compressor is heard. If not, there may be a freon leak or motor failure.
- ❄️ Make sure that no ice has formed on the back wall of the freezer (a sign of a system malfunction No Frost).
Common mistakes when turning off the freezer
Even experienced users make mistakes that lead to breakdowns. Here are the most common ones:
- ⚡ Unplugging the plug from the socket without first lowering the temperatureSudden shutdown of the compressor under load reduces it. resource.
- ❄️ Leaving ice in the freezerWhen turned on again, the ice may block the fan (No Frost) or the drainage hole.
- 🔧 Use of sharp objects to remove ice. This damages the evaporator and leads to freon leakage.
- 🕒 Turn on the freezer immediately after transportation. You must wait 4-6 hours to equalize the oil pressure in the compressor.
Another typical mistake is ignoring holiday mode. In some models (Atlant XM 6025-080) it is activated automatically when the freezer is turned off and maintains the temperature in the refrigerator compartment. +15°CIf you need to completely turn off the refrigerator, this mode should be deactivated. manually.
FAQ: Answers to popular questions
Is it possible to turn off the freezer without turning off the entire refrigerator?
Yes, but only in models with two compressors (for example, Atlant DX 4208-000) or electronically controlled (Atlant NM 6021-080). In single-compressor refrigerators, turning off the freezer stops the operation of the entire system.
How often can you turn off the freezer?
The manufacturer Atlant does not set strict restrictions, but recommends doing this no more often once every 2-3 months. Frequent switching on/off reduces the life of the compressor.
Why did the refrigerator compartment cool worse after turning off the freezer?
In single-compressor models (Atlant MX 2823), the freezer and refrigerator compartment are connected one circuit. If the freezer is turned off, the compressor operates in gentle mode, and the refrigerator compartment can heat up to +8…+10°C. The solution is to reduce the load of products or turn on the freezer at minimum power.
Is it possible to turn off the freezer for the winter if the refrigerator is on an unheated balcony?
No! At temperatures below +10°C the oil in the compressor thickens, and when turned on, this can lead to it jamming. If the refrigerator Atlant is used in an unheated room, the freezer should be turned off, and the appliance itself should be turn off the power completely and the door should be left ajar.
How to turn off the freezer in the refrigerator Atlant with a display, if the buttons do not respond?
First try resetting the settings: unplug the refrigerator for 10 minutes. If this does not help, check to see if child lock is activated (usually unlocked by holding the 🔒 button for 3 seconds). In the event of a hardware malfunction, the control panel must be replaced.