How to correctly turn off only the freezer in a Samsung No Frost refrigerator: instructions with photos and nuances

Turning off the freezer compartment in the refrigerator Samsung No Frost without turning off the main compartment is a problem that owners face when using it seasonally, saving energy, or temporarily not needing to freeze. Unlike older models with a drip system, the technique No Frost has its own characteristics: here you cannot simply pull out the cord or turn the mechanical regulator. The ventilation system and automatic defrosting require a careful approach so as not to disrupt the operation of the entire unit.

In this article we will analyze three official methods turning off the freezer (depending on the refrigerator model), and also talk about the consequences of such a decision. You will learn how to determine the type of compressor in your model, which menu settings are responsible for the freezer compartment, and what to do if, after turning off, the refrigerator begins to work incorrectly. Let us separately dwell on models with the "CoolSelect Zone" function —here the algorithm of actions is fundamentally different.

1. How to determine whether you can turn off the freezer in your Samsung model

Not all refrigerators Samsung No Frost support separate camera shutdowns. The possibility depends on two factors: number of compressors and presence of an electronic control unit. Here's how to check it:

• 🔍 One compressor (most budget models): turn off the freezer cannot without completely turning off the refrigerator. The compressor serves both chambers simultaneously.
• ⚙️ Two compressors (premium series, for example, Samsung RB37J5230SA or RS62R5001M9): the chambers work independently, the freezer can be turned off through the menu.
• 📱 Electronic control panel with a "Fridge" or "Freezer" button: if the display shows separate temperatures for the refrigerator and freezer compartments, it means separate control is supported.

To accurately identify the model, look at the sticker inside the refrigerator compartment (usually on the side wall) or on the rear panel of the case. The model code begins with the letters RB (single-compressor) or RS (double-compressor). For example:

⚠️ Attention: If your refrigerator was manufactured before 2018, even if there are two compressors, the separate shutdown function may not be available. In this case, an attempt to turn off the freezer through the menu will result in an error E-22 or E-24.

2. Step-by-step instructions for models with two compressors

If yours Samsung No Frost is equipped with two compressors, follow this algorithm. The example is given for the model Samsung RS62R5001M9, but is also suitable for other series with a similar control panel:

1. Press the button Freezer (usually located on the right side of the display) and hold it 5 secondsuntil a beep sounds.
2. The message OFF or a flashing freezer indicator will appear on the screen. This means that the chamber is turned off, but the ventilation No Frost continues to operate normally.
3. To turn on the freezer, press again Freezer and select the desired temperature (recommended value: -18°C).

In some models (for example, Samsung RF23HCEDBSR) instead of a button Freezer a touch panel is used. Here the algorithm is different:

Settings → Modes → Freezer → Off

Defreeze and remove all products|Check the temperature in the refrigerator compartment (should be +4…+5°C)|Clean the drainage hole|Close the freezer door to avoid condensation-->

⚠️ Attention: After turning off the freezer Do not unplug the refrigerator - this will lead to system failure No Frost and possible icing of the evaporator. The fan should be running in the background.

3. Alternative methods: "Vacation" mode and CoolSelect Zone

If your model does not support direct shutdown of the freezer, you can use "Vacation Mode" (Vacation). It is available in refrigerators with inverter compressors (series Samsung RF or RS after 2019). In this mode:

• 🧊 The freezer compartment maintains the temperature -12°C (energy savings up to 30%).
• 🥬 The refrigerator compartment operates in standard mode (+5°C).
• ❄️ The system No Frost continues automatic defrosting.

The mode is activated like this:

Settings → Special modes → Vacation Mode → On

For models with the function CoolSelect Zone (for example, Samsung RF23J9011SG) the freezer can be switched to refrigerator mode:

1. Press the button CoolSelect (usually located under the display).
2. Select the mode Fridge (the temperature will be maintained at the level +1…+3°C).
3. Confirm the selection with the button OK.

4. What to do if the freezer does not turn off: common ones. errors

If after all the manipulations the freezer continues to work, check the following points:

• 🔌 Child lock: in models with a touch panel (for example, Samsung Family Hub) the lock can be activated. To remove it, simultaneously press and hold the Lighting and Ice Type for 3 seconds.
• 📡 Firmware failure: if the refrigerator displays an error E-22 or E-24, a reboot is required. Turn off the power for 1 minute, then turn it on again.
• ⚙️ Incompatible model: in refrigerators with one compressor (series RB) it is physically impossible to turn off only the freezer. Attempts to do this through the service menu will lead to failure.

If the problem persists, check freezer temperature sensor. In models No Frost it is located behind the rear panel of the freezer. If it malfunctions, the system can ignore shutdown commands. You can diagnose a sensor failure using the following signs:

• The freezer runs continuously, but does not freeze.
• The display shows an incorrect temperature (for example, -30°C at room temperature inside).
• The refrigerator makes relay clicks every 5-10 seconds.

How to check the temperature sensor without tools?

Disconnect the refrigerator from the power supply for 10 minutes, then turn it on again. If, after turning on, the freezer immediately starts working at full power (the noise of the compressor is heard), and after 1-2 hours the temperature on the display has not changed, the sensor is faulty. In this case, a replacement is required (the part costs ~1500-2500 rubles, depending on the device). models).

5. Consequences of turning off the freezer: what you need to know

Disconnecting the freezer affects not only energy consumption, but also the operation of the entire refrigerator. Here are the key points:

Pay special attention humidity. The freezer No Frost has an evaporator that absorbs moisture from the air. When it is turned off, moisture may condense in the refrigerator compartment, especially if the door is opened frequently. To avoid this:

• 💧 Once a week, wipe the back wall of the refrigerator compartment with a dry cloth.
• 🍎 Store fruits and vegetables in containers with lids.
• 🔄 Set the temperature of the refrigerator compartment on +3°C (this will reduce the formation of condensation).

6. Service menu: last resort (only for experienced users)

If standard methods do not work, and you need to turn off the freezer, you can use service menu. This method is only suitable for models with electronic control and requires caution - incorrect actions can lead to firmware failure.

Instructions for refrigerators Samsung with a display (series RF, RS after 2017):

1. Unplug the refrigerator for 30 seconds, then turn it on.
2. Within 5 seconds after turning on, press and hold the buttons Lighting + Vacation (or Freezer + Fridge, depending on the model).
3. Hold until appears inscription SE (Service Mode).
4. In the service menu, select the item F01 (freezer compressor settings) and set the value 0.
5. Save the settings with the button OK and exit the menu by pressing Power Cool.

⚠️ Attention: Entering the service menu resets user settings (for example, “Super Freeze” or “Power Cool” mode). After exiting the menu, you will have to configure them again. It is also not recommended to change the parameters F05–F10 as this may lead to damage to the fan or defrosting heating element.

7. Frequently asked questions and problems after turning off the freezer

After turning off the freezer, users often encounter unexpected nuances. Let's consider the most common situations:

Question: Why did the refrigerator compartment become worse in cooling after the freezer was turned off?

Answer: In models with one compressor, cold air from the freezer enters the refrigerator compartment through a special channel. When you turn off the freezer, this flow stops and the temperature in the refrigerator may rise by 1-3°C. Solution: install the refrigerator compartment regulator on +2°C instead of the standard ones +4°C.

Question: Is it possible to completely turn off the freezer by unplugging the cord from the outlet?

Answer: No. In refrigerators No Frost when the power is completely turned off, the fan stops and moisture from the air begins to condense on the evaporator. This can lead to icing and breakdown of the system after turning it back on.

Question: How often should you turn on the freezer if it is turned off for a long time?

Answer: If the freezer is not in use, it is enough to turn it on for 1-2 hours once a month. This will prevent the sealing gum from drying out and maintain the performance of the compressor.

Why did the refrigerator become louder after turning off the freezer?

In models with two compressors, when the freezer is turned off, all the cold is generated by one compressor (for refrigeration chamber). It begins to work harder to compensate for the lack of assistance from the second compressor. This is normal and not a malfunction. The noise should decrease after 1-2 days when the temperature stabilizes.

Is it possible to turn off the freezer in a Samsung refrigerator with the Twin Cooling Plus system?

Yes, in models with Twin Cooling Plus (for example Samsung RF23HCEDBSR) freezer and refrigerator The cameras are completely independent. Here you can turn off the freezer through the main menu: Settings → Camera management → Freezer → Off.. In this case, the system No Frost will continue to operate normally.

What to do if an error appears on the display after turning off the freezer E-22?

Error E-22 indicates a problem with the freezer temperature sensor. In most cases, resetting the settings helps: unplug the refrigerator for 5 minutes, then turn it on again. If the error recurs, the sensor needs to be replaced (the part can be ordered using the code indicated on the compressor sticker).