We rehang the doors of a Samsung refrigerator with our own hands: instructions with photos and secrets of the masters

• First the freezer compartment (bottom door), then the refrigerator.
• Tighten the screws, but not all the way - leave 1-2 mm of play for adjustment.

The holes for the screws are clean (no debris/dust)|

Plastic bushings in place (if included)|

The seal is not twisted or torn|

The screws are twisted crosswise (for uniform pressure)-->

For models with water dispenser additionally:

1. Disconnect the water supply hose from the back wall (turn off the water first!).
2. Remove the dispenser bracket (4 PH2 screws).
3. When overhanging Please note that the hose must remain on the right (if you look at the refrigerator). To do this, the hose must remain on the right extension tubes.

Adjusting doors: eliminating distortions and cracks

Even when carefully re-hanging the door maybe poor closure or formation of cracks. This is due to:

• 🔄 Uneven tightening of screws (the most common mistake!).
• 📉 Sagging of the door due to wear of the hinges (relevant for refrigerators older than 7 years).
• 🧲 Magnetic imbalance seal (if the door is “repelled” from the body).

How to adjust:

1. Check the gaps: Use a piece of paper - it should press tightly seal around the entire perimeter. If the paper falls out somewhere, there is a gap.
2. Adjust the position of the door:
   • For top hinge: loosen the screws and move door left/right.
   • For bottom hinge: tighten the hexagon to raise/lower the door.
• Check the seal: If it is deformed, warm the problem area with a hairdryer (temperature 50–60°C) and shape it with your hands.

For models with electronic control (for example, Family Hub) after adjustment, it may appear error dH or dC on the display. This means that the door sensors do not work. Solution:

1. Disconnect the refrigerator from the mains for 1 minute.
2. Open and close each door 3 times in a row.
3. If the error remains, it is required resetting settings through the service menu (codes see instructions).

Common mistakes and how to avoid them

The experience of craftsmen shows that 70% of problems after self-reweighing are associated with five typical mistakes:

1. Ignoring plastic bushings:

   The bushings (aka "spacers") provide the correct gap between the door and the body. Without them, the door will cling to the seal or, conversely, dangle. Bushings are often lost when moving - they can be ordered separately (article for Samsung: DA61-01263A).

2. Tightening the screws:

   This leads to deformation of the hinges cracks in the plastic fasteners. Tighten the screws "crosswise" with a force of no more than 1.5 Nm (use a torque a screwdriver, if any).

3. Incorrect order of door removal:

   If you remove the freezer compartment first and then the refrigerator compartment, the top hinge of the refrigerator compartment may jamalways start from the top. doors!

4. Ignoring the weight of the doors:

   The refrigerator door weighs 8–12 kg, the freezer door weighs 5–7 kg. Work with an assistant or use supports (for example, a chair with with a towel).

5. Forget about the magnetic seal:

   After rehanging, the seal may “move away” due to a change in the magnetic field. Warm it up with a hairdryer and press it with a heavy book for 10 minutes.

⚠️ Attention: In refrigerators Samsung with a system No Frost (for example, Digital Inverter Compressor (For example, RT38K6**) the refrigerator may not work after rehanging. turn on for 5-10 minutes - this is normal! Do not panic and do not disassemble it again. compressor protection. The refrigerator will not turn on for 5-10 minutes - this is normal! Don't panic and don't disassemble it again.

Features for models with a dispenser and French Door

Refrigerators Samsung s water/ice dispenser (series RF, RS) require additional actions:

• 💧 Turning off the water: Turn off the supply tap and disconnect the hose from the back wall. Be prepared for the remaining water (up to 100 ml) to spill out - place a basin.
• ⚙️ Reconfiguring hoses: Included extension tubes (article number DA97-08006B) - they need to be connected if the dispenser is now on the left.
• 🔌 Checking the electronics: After rehanging, test the dispenser for leaks. If water drips, tighten plastic nut on the hose (not metal!).

For models French Door (two doors to the refrigerator compartment, for example, RF23HCED**):

• 🔄 Synchronization of hinges: The hinges of the left and right doors should be mirror symmetrical. If one door is 1 mm higher than the other, there will be a gap.
• 🧲 Double seal: At the junction of the doors there is additional magnetic tapeWhen rehanging, it must be re-glued to the other side.

In refrigerators Samsung with Ice Maker (ice generator) after rehanging, reprogramming. modulemay be required:

1. Press and hold the button Ice Type 5 seconds.
2. Select mode Reset (reset).
3. Wait for the sound signal and check the operation of the ice maker.

When it is better to call a specialist: 5 signs

Despite the apparent simplicity, in some cases independent re-hanging is riskyConsult a specialist if:

• 🔧 Your refrigerator older than 2010 —older models use asymmetrical hingeswhich cannot simply be rearranged.
• ⚡ An error appears on the display E1, E2 or dH even after resetting the settings.
• 💦 After rehanging, water flows from under the refrigerator (the drain hose may be damaged drain hose).
• 🔊 Appears creaking or knocking when opening the doors - this is a sign of wear on the hinges.
• 📄 You have a model with vacuum insulation (for example, Samsung Bespoke) - here required special equipment to regulate pressure.

Cost of calling a technician to rehang doors in 2026:

• Double chamber refrigerator: 1500–2500 rubles.
• Side-by-Side or French Door: 2500–3500 rubles.
• Models with dispenser: 3000–4000 rubles (includes reconfiguration of the water supply system).

If you decide to act on your own, but something goes wrong, don’t panic. In 90% of cases, problems are solved. adjusting the hinges or replacing the seal (cost of a new seal for Samsung is from 1200 rubles). The main thing is not to tighten the screws with excessive force and do not ignore the plastic bushings.

FAQ: answers to frequently asked questions

Is it possible to rehang the doors on a Samsung refrigerator with an electronic display (Family Hub)?

Yes, but after reversing you will need to factory reset through the service menu:

1. Press the Power Cool and Power Freeze buttons simultaneously for 5 seconds.
2. Enter the code 8639 (for models 2020–2023 years).
3. Select item Door Reverse and confirm.

If the display shows an error dC, open and close each door 3 times in a row.

What to do if, after hanging, the refrigerator becomes loud work?
This is normal for the first 2-3 hours - the compressor pumps the refrigerant after changing the position of the doors. If the noise does not go away:
• Check whether the door is touching the housing (maybe resonance).
• Make sure the refrigerator is level (use a level).
• If there is noise rattling - tighten the hinge screws.
Do you need to defrost the refrigerator before rehanging?

No, if you have a model with No Frost. For refrigerators with drip system (for example, Samsung RT-28**) it is recommended:

1. Turn off the refrigerator 4-6 hours before work.
2. Remove ice from the seal (you can use a hairdryer).
3. Wipe the rubber band alcohol for elasticity.

This will prevent damage to the seal when removing the doors.

Where can I get the fastening diagram for my Samsung model?

Official diagrams there are:

• In operating instructions (section "Door Reversal").
• On the website Samsung in the section Support → Spare parts and accessories (enter model refrigerator).
• In service manuals (search for "refrigerator model service manual PDF").

For models Bespoke diagrams are not published - contact an authorized service center.

How long does it take to rehang the doors?

The time depends on the type of refrigerator:

• Two-chamber (without dispenser): 40–60 minutes.
• Side-by-Side: 1.5–2 hours (due to the weight of the doors).
• C dispenser: 2–2.5 hours (including reconfiguration of the water supply).

If you are doing this for the first time, stock up 3–4 hours taking into account adjustment.