A clogged drainage hole in the refrigerator Beko is one of the most common causes of water accumulation under vegetable drawers or at the bottom of the chamber. If you notice a puddle inside the refrigerator, an unpleasant odor or an ice crust on the back wall, the problem most likely lies in the drainage system. In this article we will look how to clean the drainage hole in a Beko refrigerator without calling a specialist, using available means.
The procedure for cleaning the drainage in models Beko (for example, GNE114620X, CNA335K20X or DS 333020) has its own nuances due to design features. Unlike other refrigerator brands, the drain hole is often located under the plastic evaporator panel, which requires careful disassembly. We will describe in detail each stage - from diagnostics to the prevention of repeated blockages, and also give advice on caring for the system No Frost and drip models.
Signs of a clogged drain hole in a Beko refrigerator
Before you start cleaning, it is important to make sure that the problem is in the drainage. Here are the key symptoms:
- 💧 Accumulation of water under the containers for fruits/vegetables - the liquid does not go into the drainage tube and accumulates at the bottom.
- ❄️ Ice crust on the back wall of the refrigerator compartment (typical for models with drip system).
- 🤢 Unpleasant odor from the refrigerator, even after washing - bacteria multiply in the blockage.
- 🔊 Gurgling sounds during operation - water does not flow evenly, but passes through the blockage with noise.
- 🚨 Error on the display (if a model with electronic control, for example, Beko RCSK 310M20 S) - a code may be displayed
E1orE4.
In models Beko s system No Frost clogged drainage is often accompanied by ice formation in the lower part of the freezer compartment this is due to the fact that condensate is not drained through the tube and freezes. If you observe at least 2-3 signs from the list, it is time to clean the drainage system.
⚠️ Attention: If water accumulates inside the freezer. cameras, the problem may be due to a clogged evaporator drain or a malfunction of the defrost heater. In this case, it is better to contact a specialist - independent repairs can damage the freon circuit.
Causes of clogged drainage in Beko refrigerators
The drainage hole in the refrigerator Beko gets clogged due to small particles of food, dust and mold getting into it. Let's look at the main reasons:
- 🍎 Crumbs and particles of food - when stored carelessly, pieces of food get into it. into the hole and form a plug.
- 🧀 Fat and oils - flow down the back wall and solidify in the drainage tube, narrowing its lumen.
- 🍄 Mold and mucus - multiply in a humid environment, especially if the refrigerator is rarely wash.
- 🧹 Dust and dirt - penetrate when doors are open or during cleaning.
- 🧊 Ice in the tube - in models with No Frost condensation can freeze and block the outflow water.
In refrigerators Beko s drip system (for example, Beko TSE 1042) drainage blockage often occurs due to incorrect installation: if the unit is not level, water does not flow into the hole, but spreads along the bottom. Also, the problem is aggravated if you rarely defrost the refrigerator or use aggressive detergents that destroy the plastic of the tube.
| Refrigerator type | A common cause blockage | Consequences |
|---|---|---|
| Drip system | Accumulation of fat and crumbs in the drainage hole | Water at the bottom of the chamber, unpleasant odor |
| No Frost | Ice plug in drainage tube | Ice freezing in the freezer, error E1 |
| Two-chamber with bottom freezer | Mold in the drainage channel of the refrigerator | Black spots on the plastic, water under the drawers |
| Side-by-Side | Clogged drain hose due to improper care | Water leakage onto the floor, corrosion of the body |
⚠️ Attention: If your refrigerator Beko is equipped with a system NeoFrost (for example, models Beko GNE120620X or Beko CNPE5935X), the drainage tube may have bends, which makes cleaning it more difficult. In this case, do not use sharp objects - the risk of damaging the tube is higher!
Preparation for cleaning: tools and safety measures
Before to clean the drainage hole in the refrigerator Beko, prepare everything you need. You will need:
- 🧻 Cotton swabs or toothpicks — to clean the visible part of the hole.
- 🧴 Syringe (bulb) or syringe — to rinse the tube with water.
- 🧼 Soap solution or refrigerator cleaner (for example, Topperr 3004 or Sano Refrigerator Cleaner).
- 🔧 Flat screwdriver - for removing the protective panel (in models with No Frost).
- 🧤 Rubber gloves —to protect your hands from dirt and chemicals.
Also prepare warm water (about 40°C) and a towel to collect liquid. If the blockage is serious, you may need it. wire with a diameter of 2-3 mm (for example, from hangers) or special brush for cleaning drainage (sold in household goods stores).
Measures safety:
- ⚡ Unplug the refrigerator required —even if you do not disassemble the back panel, the risk of a short circuit when working with water remains.
- 🧊 Remove all food and defrost the refrigerator (if there is ice on walls). In models Beko c No Frost it is enough to turn off the power for 1-2 hours.
- 👶 If there are children or pets in the house, make sure that they do not have access to the disassembled refrigerator - small parts (screws, lids) can be dangerous.
Unplug the refrigerator from the outlet|Take out all the food|Defreeze the chamber (if there is ice)|Prepare tools and water|Prohibit access to children/animals-->
Step-by-step instructions: how to clean the drainage hole in the Beko refrigerator
The cleaning process depends on the type of your refrigerator Below is a universal one. instructions suitable for most models Beko (including CN 335120 X, DS 333020, RCSK 270M20 S etc.).
Step 1: Find the drainage hole
In refrigerators Beko the drainage hole is usually located:
- B drip models —on the back wall of the refrigerator compartment, under the evaporator (plastic panel with a ribbed surface).
- B No Frost —under the bottom shelf of the freezer or behind the protective panel (removal required).
The hole looks like a small round or oval depression (diameter 5-8 mm). In some models, it is covered with a plastic plug.
Step 2: Remove visible debris
Use a cotton swab or toothpick carefully remove dirt from the hole. Don't press too hard - the plastic may crack. If the debris is dense, soak the stick in the soapy solution.
Step 3: Rinse the drainage tube
Fill a syringe or syringe (without a needle!) with warm water and sharply inject it into the hole. Repeat 3-4 times. If the water flows freely, the blockage has been removed. If not, proceed to the next step.
Step 4: Cleaning with a wire (if there is severe blockage)
If washing with water did not help, take one soft wire (for example, from hangers) and carefully push it into the drainage hole to a depth of 10-15 cm. Using rotating movements, destroy the plug, then rinse the tube with water.
⚠️ Attention: In models Beko with a system NeoFrost the drainage tube may have turns at an angle of 90°. If the wire hits an obstacle, do not press harder - you may puncture the tube. It is better to use flexible cable (for example, from an old antenna).
Step 5: Cleaning the drain tray
At the bottom of the refrigerator (usually on the back wall behind the decorative panel) is located drain panwhere water flows. It also needs to be washed:
- Turn off the refrigerator and carefully remove the bottom panel (it is secured with latches or screws).
- Take out the pan and wash it under running water and detergent.
- Wipe dry and install back.
Step 6: Disinfection and drying
After cleaning, treat the hole soda solution (1 tablespoon per glass of water) or with a special antibacterial agent. Leave the refrigerator open for 1-2 hours to dry.
Features of cleaning drainage in Beko refrigerators with No Frost
Models Beko with system No Frost (for example, Beko RCSK 310M20 S, Beko GNE114620X) have a more complex drainage system. Here, the blockage often forms not in the hole itself, but in the tube behind the back panel of the freezer. To get to it:
- Unplug the refrigerator and defrost it (at least 4-6 hours).
- Remove the back panel of the freezer - it is secured with screws (use a Phillips screwdriver).
- Under the panel you will see drain tube (usually white or transparent). Carefully disconnect it from the evaporator.
- Rinse the tube with warm water and detergent, using a brush or wire.
- Dry the tube with a hairdryer (at minimum power) and put it back.
In models with NeoFrost the drainage tube can be branched —one branch goes to the refrigerator compartment, the other to the freezer. If the blockage is in both branches, clean them one by one.
What to do if the tube is damaged?
If during cleaning you accidentally pierced the drainage tube, it can be temporarily sealed silicone glue (for example, Moment Germent). However, this solution is short-lived - over time the tube will have to be replaced. For models Beko original spare parts can be ordered using the part code (indicated on the sticker inside the refrigerator).
How to flush the drainage: folk remedies and professional chemistry
To clean the drainage hole in the refrigerator Beko you can use both improvised means and specialized chemicals. Let's consider the most effective options:
| Remedy | How to use | Pros | Cons |
|---|---|---|---|
| Soda solution | 1 tbsp. spoon of soda per 200 ml of water. Pour into the hole, rinse with water after 15 minutes. | Safe, kills bacteria | Weakly copes with grease plugs |
| Vinegar (9%) | Mix with water 1:1, pour into drainage, through Rinse for 10 minutes. | Dissolves fat, disinfects | Pungent odor, can damage rubber seals |
| Citric acid | 1 teaspoon per glass of water. Pour in, wait 20 minutes, rinse. | Eliminates odor, dissolves plaque | Less effective against mold |
| Topperr 3004 | Apply to a cotton swab and clean the hole. Rinse with water. | Especially for refrigerators, kills 99% of bacteria | More expensive than folk remedies |
| Sano Refrigerator Cleaner | Spray into the drain, wipe and rinse after 5 minutes. | Fast-acting, without odor | Not sold in all stores |
For preventive cleaning a soda solution or citric acid is sufficient. If the blockage is serious (for example, the tube is clogged with grease), it is better to use Topperr 3004 or Sano —they contain surfactants that dissolve organic deposits.
⚠️ Attention: Never use for drainage cleaning aggressive agents (for example Domestos, Whiteness or acetone). They can damage the plastic tubes and seals, which will lead to freon leakage or compressor failure.
Prevention of blockages: how to avoid repeated problems
To prevent the drainage hole in the refrigerator Beko from becoming clogged again, follow these recommendations:
- 🧼 Wash the refrigerator every 1-2 months —use a soft sponge and soap solution. Pay special attention to the back wall and the area around the drainage hole.
- 🥩 Store food in closed containers this will prevent crumbs and grease from getting into the drain.
- 🧊 Defrost the refrigerator 2 times a year (even if you No Frost). This will help remove plaque and prevent the formation of ice jams.
- 📏 Check the level of the refrigerator —it should stand level, without distortions. Use a building level.
- 🛠️ Install a mesh filter at the drainage hole (sold in hardware stores). It traps debris, but does not interfere with water flow.
If your refrigerator Beko is equipped with a function auto-defrost, do not turn it off for a long time - this leads to excessive condensation formation and accelerated drainage clogging. Also avoid placing the refrigerator near heat sources (stove, radiator) - this increases the load on the water drainage system.
FAQ: Frequently asked questions about cleaning the drainage in Beko refrigerators
Is it possible to clean the drainage without turning off the refrigerator?
No, unplug the refrigerator required. Firstly, it is safe (risk of electric shock when working with water). Secondly, in models with No Frost the fan can turn on at any time and interfere with cleaning. The exception is if you simply wipe the visible part of the hole with a cotton swab, but in this case it is better to turn off the power to the unit.
What to do if after cleaning water still accumulates?
If cleaning the drainage did not help, check:
- Refrigerator level —it should be level (use a level).
- Integrity of the drainage tube —if it is cracked, it needs to be replaced.
- Operation of the defrost heater (in models No Frost) - if it breaks, the ice blocks the drainage.
- Plug of the hole - in some models Beko it may be installed incorrectly after cleaning.
If the problem persists, call a technician, as the cause may be a malfunction of the defrost system.
How often should you clean the drainage hole?
Recommended frequency:
- For drip models - once every 3-6 months.
- For No Frost - once every 6-12 months (but you should check the drainage condition every 3 months).
- If the refrigerator is used intensively (for example, in a cafe or a large family) - once every 1-2 months.
Signs that it is time to clean the drainage ahead of schedule: water at the bottom, unpleasant odor, gurgling sounds.
Is it possible to use wire from hangers to clean the drainage?
Yes, but with caution:
- The wire should be soft (aluminum or copper), without burrs.
- Do not press too hard - there is a risk of piercing the tube.
- It is better to wrap the end of the wire soft clothto avoid scratching the plastic.
For models with NeoFrost it is better to use flexible cable (for example, from an antenna) - it has less risk of damaging the curved tube.
What is the difference between cleaning the drainage in Beko refrigerators with No Frost and a drip system?
Main differences:
| Parameter | Drip system | No Frost |
|---|---|---|
| Drain location | On the back wall of the refrigerator compartment | Behind the back panel of the freezer |
| Main cause of blockage | Crumbs, grease, mold | Ice plugs, condensation |
| Difficulty of cleaning | Simple (access without disassembly) | Complex (requires panel removal) |
| Frequency of prevention | Once every 3-6 months | Once every 6-12 months |