Setting the temperature in the Combustion refrigerator: instructions for all models

Brand refrigerators Gorenje (Combustion) are famous for their reliability and modern technologies, but even the most advanced technology requires the correct settings. Incorrectly selected temperature conditions can lead to food spoilage, increased energy consumption, or even compressor failure. In this article, we will look at how to correctly set the temperature in a refrigerator Gorenje —from basic models to electronically controlled inverter systems.

You will learn what values ​​are considered optimal for the refrigerator and freezer compartments, how the setting affects the shelf life of food and electricity consumption, and what to do if the refrigerator does not maintain the set temperature. We will pay special attention to common mistakes that users make when adjusting, and we will give practical advice on diagnosing malfunctions.

Optimal temperature conditions for refrigerators Combustion

The manufacturer Gorenje recommends maintaining a temperature in the refrigerator compartment from +2°C to +5°C, and in the freezer - from -18°C to -24°C. However, these values can be adjusted depending on:

• 📦 The load of the chambers —the more products, the colder the mode should be;
• 🌡️ Room temperatures — in hot weather the refrigerator works more intensely;
• 🍎 Type of stored products —meat, fish and dairy products require lower temperatures;
• ⚡ Energy efficiency class —models with an inverter compressor (Gorenje NRK6191, Gorenje RK60359) automatically adjust to conditions.

It is important to understand that in most models Combustion, the temperature in the freezer is not regulated separately - it depends on the settings of the refrigerator compartment and the freezing mode. The exception is two-compressor models (Gorenje FN6192), where each chamber is controlled independently.

To check the accuracy of the settings, use a household thermometer (for example, Xiaomi Mijia Bluetooth). Place it in the center of the refrigerator for 12 hours - this will give objective data. If the readings differ from the set values by more than 2°C, calibration or diagnostics is required.

Mechanical control: adjusting the temperature with a knob

Most budget models Gorenje (for example, Gorenje RK4121 or Gorenje RK4181) are equipped with a mechanical thermostat - rotary knob with divisions from 1 to 5 (less often to 7). The higher the number, the colder it is in the chamber. The manufacturer recommends setting the knob to position 3 for standard conditions (room temperature +20...+25°C, average load).

Setting algorithm:

1. Clean the refrigerator from food (especially in the area near the temperature sensor).
2. Turn the knob on 3 and leave the refrigerator empty for 6-8 hours.
3. Check the temperature with a thermometer. If the refrigerator compartment is above +5°C, increase the value by 1 division. If below +2°C, reduce it.
4. Repeat the check 12 hours after adjustment.

In the freezer compartment of mechanical models there is usually a separate mode switch:

• 🌨️ Economy (-12°C) - for short-term storage;
• ❄️ Normal (-18°C) - standard mode;
• ❄️❄️ Super (-24°C) - for quick freezing (no more than 24 hours).

Make sure that the handle turns smoothly, without clicks|

Clean the door seal from dirt|

Check that that the refrigerator is level (misalignment affects closing)|

Do not place food close to the back wall (interferes with air circulation)

-->

⚠️ Attention: If, after setting the handle to the maximum value (5), the temperature in the refrigerator compartment does not drop below +8°C, this may indicate a freon leak or a malfunction thermostat. In this case, diagnostics of the master is required.

Electronic control: setting via display

Models with electronic control (Gorenje NRK6191, Gorenje NK6191) allow you to set the temperature with an accuracy of 1°C. Settings are carried out via the touch display or buttons +/– on the panel. Algorithm of actions:

1. Press the button Fridge (or the refrigerator icon) to select the refrigerator compartment.
2. Use the buttons +/– set the value from +2°C to +8°C (recommended +4°C).
3. Click Freezer (or snowflake) and set the freezer from -16°C to -26°C (optimal -18°C).
4. Confirm settings button OK or automatically (after 5 seconds of inactivity).

In models with the function SuperCool (for example, Gorenje NRK6192), a temporary temperature reduction to +2°C is available for rapid cooling of a large volume of products. Activated. button SuperCool for 6–12 hours, after which the refrigerator automatically returns to the previous settings.

For the freezer, a similar function is called SuperFreeze (-30°C 24–48 hours. Important: long-term use of these modes increases energy consumption by 20–30%.

Setting features in models with NoFrost and LowFrost

Refrigerators Gorenje s system NoFrost (Gorenje NRK6192, Gorenje NKI6191) automatically regulate air circulation, which ensures uniform cooling. In such models:

• 🔄 The temperature is restored faster after opening the door;
• ❄️ There is no need for manual defrosting;
• ⚡ Energy consumption is higher by 10–15% compared to drip models systems.

Systems LowFrost (Gorenje RK60359are characterized by the formation of a small layer of frost, so it is recommended:

• Set the freezer temperature to -20°C (instead of standard -18°C);
• Defreeze the chamber once every 6 months (even with auto-defrost);
• Do not load food close to the ventilation openings.

In models with dynamic cooling (for example, Gorenje ORK2291) a fan is used to distribute cold air. Here it is critical to keep the air ducts clean - blockages lead to blockages. compressor overheating and temperature increase by 3–5°C.

How to check the fan operation in NoFrost?

Open the refrigerator and listen - when the door is closed, you should hear a slight air noise (like in a computer cooler). If it is not there, the fan may be faulty or the ducts are clogged. In this case, professional cleaning is required.

Common mistakes when setting the temperature

Even experienced users make mistakes that lead to improper operation of the refrigerator. Here are the most common of them:

1. Ignoring external conditions. If the refrigerator is placed next to a stove or in direct sunlight, the thermostat will not work correctly. The optimal distance from heat sources is 50 cm.
2. Overloading of products. Overcrowded shelves block air circulation, which can cause temperature differences in different zones by 5–7°C.
3. Incorrect placement of the thermometer. You need to measure the temperature in the center of the chamber, and not on the door or next to the lamp.
4. Continuous use of SuperFreeze. This mode is intended for short-term freezing, and not for everyday use.

Another typical problem is the door does not close tightly. You can check this with a sheet of paper: place it between the seal and the body. If the sheet is easily pulled out, the seal requires replacement or cleaning.

⚠️ Attention: If, after adjusting the settings, the refrigerator Gorenje emits a prolonged hum (more than 10 minutes), this may indicate an overload of the compressor. Immediately return the thermostat knob to 1–2 and let the appliance “rest” for 2-3 hours.

Fault diagnosis: when the setting does not help

If the refrigerator does not maintain the set temperature despite the correct settings, the reasons may be the following:

For primary diagnostics:

1. Unplug the refrigerator for 1 hour, then turn it on again. If the problem persists, there is a hardware malfunction.
2. Check the voltage in the outlet (should be 220–240 V). Voltage surges are a common cause of failures in electronic units.
3. Inspect the capacitor (grid on the back wall). If it is hot, the compressor is overloaded.

In models with electronic control (Gorenje NRK6191), if there is a malfunction, an error code may be displayed on the display. Decoding of popular codes:

• E1 — problem with the refrigeration chamber sensor;
• E2 — malfunction of the freezer chamber sensor;
• E3 —defrost system error;
• E4 —compressor malfunction.

⚠️ Attention: Design details and error codes may vary depending on the model year. For an accurate diagnosis, check the instructions for your refrigerator or contact a service center Gorenje.

Tips for energy saving without loss of cooling quality

Refrigerators Gorenje class A+++ (for example, Gorenje NRK6192) consume up to 30% less electricity compared to class models A+. However, even in economical devices, you can further reduce consumption by following these recommendations:

• 🌿 Defrost regularly (for models without NoFrost) - ice 5 mm thick increases consumption by 10%;
• 🔌 Do not place the refrigerator next to the battery - every degree of external heat increases consumption 2–3%;
• 📦 Store food in closed containers - open liquids (soups, milk) increase humidity and load on the compressor;
• ☀️ Use the "Eco" mode (if any) - saves up to 15% electricity with minimal loss of freezing quality.

Another effective method is load optimization. Do not fill the refrigerator to capacity: free space ensures normal air circulation. Optimal load - 70–80% from the volume.

In models with an inverter compressor (Gorenje NRK6191), energy consumption directly depends on the frequency of door opening. Each time you open, the temperature inside rises by 1–3°C, and the compressor takes 5-10 minutes to restore the mode.

FAQ: Frequently asked questions about setting the temperature in Burning refrigerators

How to reset the Burning refrigerator settings to factory settings?

In most models with electronic control (Gorenje NRK6191, Gorenje NK6191), the reset is carried out by holding the button SuperCool + SuperFreeze for 5 seconds. In mechanical models, it is enough to turn the thermostat knob to 0, wait 1 minute and set the value 3.

Why is it -20°C in the freezer, but the food is melting?

This may be caused by:

1. The door is not tightly closed (check the seal);
2. Frequent opening of the freezer;
3. Failure of the air circulation system (in models with NoFrost).

Also make sure that the products are packed tightly - open bags allow moisture to pass through, which creates the illusion "thawing."

Is it possible to turn off the freezer if it is not needed?

In two-compressor models (Gorenje FN6192), the freezer can be turned off separately - to do this, set the temperature to 0°C or press the button Freezer Off (if available). In single-compressor refrigerators, turning off the freezer will cause the entire unit to stop.

How often should you defrost the Burning with LowFrost refrigerator?

The manufacturer recommends defrosting the chamber once every 6 months. If the frost layer exceeds 3–5 mm, defrosting should be done earlier. Use a plastic scraper (not metal!) and warm water to speed up the process. LowFrost Once every 6 months. If the frost layer exceeds 3–5 mm, defrosting should be done earlier. Use a plastic scraper (not metal!) and warm water to speed up the process.

Why does the Combustion refrigerator make a lot of noise during operation?

The noise can be caused by:

• Fan operation in models with NoFrost;
• Vibration of the compressor (check if the refrigerator is level);
• Clogged drainage system (gurgling sounds).

If the noise is accompanied by an increase in temperature, this may indicate a compressor malfunction. The normal noise level for refrigerators Gorenje is up to 40 dB.