A two-chamber refrigerator Indesit should automatically turn off for 10–20 minutes every hour of operation. If the unit is running without stopping for days, this does not just increase energy consumption - it will quickly fail. In 80% of cases, the problem is solved without calling a technician, but it is important to correctly diagnose the cause.
First, check the obvious: whether the mode is set super freezing (Super Freeze) or whether the function is enabled vacations (Holiday). These options block automatic shutdown. If the buttons do not light up and the refrigerator still does not “rest”, read on - we will look at 10 most common reasons and ways to eliminate them.
⚠️ Attention: If The compressor Indesit not only does not turn off, but also gets very hot (the housing is hot, a hum is heard), immediately disconnect it from the network. This is a sign motor wedge - further work will lead to a short circuit.
1. The thermostat (thermostat) is faulty
The thermostat is the “brain” of the refrigerator, which monitors the temperature and sends a signal to the compressor to turn on/off. If it breaks, the motor will work continuouslyas it does not receive a command to stop.
How to check the thermostat in the refrigerator Indesit:
- 🔧 Unplug the refrigerator and remove all food from the chamber.
- 🔍 Remove the protective casing (usually secured with latches or screws) - the thermostat is located next to the lighting lamp.
- 📊 Test the contacts with a multimeter: at room temperature between terminals 3 and 4 there should be
0 Ohm(closed), when cooling (place the sensor in ice) - open.
If the resistance does not change, the thermostat must be replaced. For models Indesit C 132 G, T 160 and similar ones, a universal thermostat K59-L1438 or original 30003907.
2. The temperature sensor has failed (in models with electronic control)
Modern refrigerators Indesit (for example, series BIAA 13 or DF 5200) are equipped with electronic boards and sensors instead of a mechanical thermostat. If the sensor breaks, the board does not receive correct temperature data and causes the compressor to work without stopping.
Symptoms of sensor failure:
- 🌡️ The display shows an incorrect temperature (for example,
+15°Cat real-2°C). - 🔄 Refrigerator freezes too much, but does not turn off.
- ⚡ An error blinks on the panel
F04,F05orF07(error codes Indesit).
For diagnostics you need sensor continuity a multimeter. Resistance of a working sensor at 0°C —about 5 kOhm, at +25°C — 1.5–2 kOhm. If the values are outside the limits, the sensor is changed.
3. compressor jamming
The compressor is the “heart” of the refrigerator. If it is worn out or jammed, the motor may work without stoppingbut not cool properly. In models Indesit with one compressor (for example, C 168 NF) this leads to overheating. both cameras.
How to recognize a problem with the compressor:
- 🔊 Loud hum or knocking during operation (the sound is different from the usual buzzing).
- 🔥 Compressor housing (black "tank" at the back) is hot - the temperature is higher
70°C. - ❄️ The refrigerator does not freeze well, despite continuous operation.
To check, turn off the refrigerator, wait for the compressor to cool down (2-3 hours) and start it again If the motor is does not start at all or immediately turns off with a click, this is a sign interturn short circuit - replacement required.
What to do if the compressor is jammed?
If the motor does not spin, but makes noise humming, try turning it on manually: turn off the refrigerator, remove the start relay and carefully turn the shaft through the hole with a screwdriver. If the shaft does not rotate, the compressor needs to be replaced.
4. Freon leak or clogged capillary tube
Freon is a refrigerant that circulates through the system and cools. chamber. If it leaks (for example, due to corrosion of the tubes) or the capillary tube is clogged, the compressor will work idletrying to reach the set temperature.
Signs of a freon leak:
- ❄️ The freezer compartment hardly cools, and the refrigerator compartment is too warm.
- 🕳️ Oil stains are visible on the back wall (freon leaves along with the oil).
- ⏳ The compressor works non-stop, but there is no result.
It is impossible to fix the leak on your own - it requires evacuating the system refilling with freon. In service centers Indesit this service costs from 3,500 to 6,000 rubles (depending on the model).
5. Problems with the door seal
The rubber seal (around the perimeter of the door) loses elasticity over time, cracks or comes off. Because of this, warm air enters the chamber, and the refrigerator is forced to work continuously, trying to compensate for the heat inflow.
How to check the seal:
- 📄 Take a sheet of paper, close the door and try to pull it out. If the sheet comes out easily, the seal is not airtight.
- 👁️ Shine a flashlight inside the closed refrigerator: if light is visible, there are gaps.
- 🧼 Clean the rubber band from dirt and grease - sometimes this is enough to restore the seal.
If The seal is damaged, it needs to be replaced. For Indesit original rubber bands are suitable 481247866914 (for models with a width of 55 cm) or 481247866915 (60 cm) Cost - from 1,200 to 2,500 rubles.
6. Incorrect installation or external factors
Sometimes the refrigerator does not turn off due to external reasonsand not breakdowns. Here's what you need to check:
| Problem | Signs | Solution |
|---|---|---|
| The room temperature is too high | The compressor runs longer than usual, but turns off | Move the refrigerator away from the stove/battery or install an air conditioner |
| Poor ventilation of the rear wall | Overheating of the compressor, frequent shutdowns due to thermal protection | Move the refrigerator 5–10 cm from the wall, clean the grill from dust |
| Uneven floor (door skewed) | The door does not close tightly, the seal wears out faster | Adjust the legs of the refrigerator to the level |
⚠️ Attention: If the refrigerator Indesit is located in an unheated room (for example, in a country house in winter), the compressor can work without stopping due to the ambient temperature being too low. The optimal range is +16...+32°C.
7. Failure of the control board (in electronic models)
In refrigerators Indesit with a display (series BIAA, DFE) the electronic board is responsible for the operation of the compressor. If it fails, the motor may receive false signals and work continuously or, conversely, turn off too often.
Signs of a board malfunction:
- 📛 Random characters or errors appear on the display (
F01,F03). - 🔄 The modes switch on their own.
- ⚡ The refrigerator does not respond to button presses.
Independent repair of the board is almost impossible - flashing or replacement is required. In the service Indesit this service will cost 4,000–7,000 rubles. Before repairing, check whether the fuse on the board has burned out (sometimes you can replace it yourself).
What to do if the refrigerator Indesit does not turn off: step-by-step instructions
Before Before calling a technician, follow these steps:
If after all the checks the problem remains, contact the service. For warranty repairs you will need:
- 📄 Refrigerator passport (with the date of purchase).
- 🏷️ Warranty card (if the period has not expired).
- 📞 Receipts or store details (to confirm the purchase).
⚠️ Attention: If the refrigerator Indesit is under warranty, do not disassemble it yourself - this will void the warranty. Take a photo of the error on the display (if any) and contact an authorized service center.
FAQ: Frequently asked questions about the continuous operation of the refrigerator Indesit
Is it possible to operate the refrigerator if it does not turn off?
No. Continuous operation leads to overheating of the compressor and its breakdown. Maximum - 1-2. day until you eliminate the cause. If the compressor is already hot, unplug the refrigerator.
How much does it cost to repair a refrigerator Indesitthat does not turn off?
The price depends on the breakdown:
- 🔧 Replacing the thermostat - 1,500–2,500 rub.
- 🖥️ Repair of control board — 4,000–7,000 rub.
- ❄️ Freon refilling — 3,500–6,000 rub.
- 🔄 Replacement compressor - 8,000–12,000 rubles.
If the refrigerator is older than 8–10 years, repairs may be unprofitable.
How to reset an error on a refrigerator Indesit with a display?
To reset an error (for example, F04 or F05) press and hold the button Super (or Ok, depending on the model) for 5-10 seconds. If the error appears again, diagnostics are required.
Why new does the refrigerator Indesit work without stopping for the first day?
This is normal. After the first turn on, the refrigerator gains temperature within 12-24 hours. If after a day it does not turn off, check the settings and the tightness of the door.
Can the refrigerator not turn off due to power surges?
Yes. If the network voltage is lower 190 V or higher 240 V, the compressor is unstable. Install a voltage stabilizer (for example, Resanta ASN-1000).