Ariston refrigerator beeps: 12 reasons and what to do to eliminate the sound

A constant squeaking sound from the refrigerator Ariston is a signal that cannot be ignored. This sound can mean either banal forgetfulness (an open door) or a serious breakdown that threatens food spoilage or equipment failure. In 80% of cases, the problem can be solved on your own, without calling a technician.

In this article we will analyze all the possible reasons why your refrigerator squeaks, buzzes or makes intermittent sounds from operating errors to compressor malfunctions. You'll learn how to diagnose a problem by the nature of the sound, which buttons to press to reset the error, and when professional repairs are actually needed. We will pay special attention to models Ariston Hotpoint with a system No Frost and electronic control, since they more often than others give false signals.

If the refrigerator beeps continuously — This is one scenario, if the sound appears periodically (for example, at night) - another. We will look at both options and also provide a checklist for a quick check. For convenience, the information is structured into blocks: from simple to complex.

1. The most common causes of squeaking (check first)

Start with the obvious. In 6 out of 10 cases, the squeak of the refrigerator Ariston is associated with user errors, and not with a breakdown. Here's what you need to check before any repair:

• 🚪 The door is not closed tightly. Even a small gap of 2–3 mm can trigger the sensor. Check the rubber seal - it may be dirty or deformed.
• ❄️ The temperature in the chamber is higher than normal. If you have recently loaded warm food or frequently opened the door, the refrigerator may beep until it restores mode.
• ⚡ Power surge. Models with an electronic display (Ariston MBA 2200, Hotpoint A+) are sensitive to changes. A squeak may indicate a malfunction of the board.
• 🔄 Super freezing mode. If the function is activated Super Freeze, the refrigerator will beep when the door is opened or at the end of the cycle.

Pay special attention to display (if it is available). On models Ariston with electronic control (BSA 2201, HBM 1182), an error code is often displayed when beeping - for example, E1 (problem with the temperature sensor) or E4 (fan malfunction). If there is a code, go straight to the section about error decoding.

If after checking these points the squeaking does not stop, move on to the next one block. Perhaps the problem lies deeper.

2. Squeaking due to faulty sensors: how to check

Temperature and humidity sensors are the weak point of refrigerators Ariston with the system No Frost. If at least one of them fails, the control unit begins to produce false signals, including a squeak. Let's look at the typical symptoms:

• 🌡️ Temperature sensor. The refrigerator beeps continuously, although the door is closed and the food is frozen. The display may light up E1 or E2.
• ❄️ Defrost sensor. The squeak appears periodically, often at night, when the defrost mode is turned on. Ice build-up may form on the back wall.
• 🌀 Fan sensor. The sound is accompanied by a hum or crackling the blades clinging to the ice or broken.

To check the sensors yourself, follow these steps:

1. Unplug the refrigerator for 10 minutes, then turn it on again. Sometimes this resets the error.
2. If the squeak returns, look for sensors (usually they are located inside the cameras, behind plastic panels). In models Ariston Hotpoint the temperature sensor looks like a small plastic cylinder on a wire.
3. Carefully disconnect the sensor connector and check it with a multimeter in resistance measurement mode. At room temperature, the resistance should be in the range 4–6 kOhm.

If the resistance of the sensor is equal to 0 (short circuit) or infinity (open), it must be replaced. For models Ariston sensors with article numbers C00368000 (temperature) and C00368001 (defrost) are suitable. They can be ordered at service centers or at AliExpress.

⚠️ Attention: Do not use a refrigerator with a faulty temperature sensor for more than 24 hours. This can lead to overheating of the compressor and its breakdown.

3. Decoding error codes on the display

Models Ariston with electronic control (HBM 1182, MBA 2201, Hotpoint A++) often display an error code on the display when beeping. Here is the complete decoding table:

If the display lights up F1, this is a serious signal. In 30% of cases, it helps resetting the settings:

1. Unplug the refrigerator.
2. Press and hold the button Super Cool (or Super Freeze) for 10 seconds.
3. Connect the power back without releasing the button.

For models without a display (for example, Ariston BCB 33), a malfunction is indicated by flashing light or a combination of flashing lights. You will find a decoding for your model in the instructions (section "Error Indication").

4. Squeaking due to icing and problems with the No Frost system

Refrigerators Ariston with the system No Frost (HBM 1182, MBA 2201) often squeak due to ice on the fan or evaporator. This happens when:

• 🍂 The drainage hole is clogged (water does not drain, ice forms).
• 🔥 The defrosting heating element (heater) does not work.
• ❄️ The freezer door is not closed tightly, and moisture gets in inside.

To fix the problem:

1. Unplug the refrigerator and defrost it for 12–24 hours. Do not use a hairdryer or hot water - this may damage the plastic.
2. After defrosting, check the drainage hole (usually located on the back wall of the refrigerator compartment). Clean it with a cotton swab or a cocktail straw.
3. If ice forms again after 1-2 weeks, the defrost heating element is likely malfunctioning. Its resistance should be 20–40 Ohm (checked with a multimeter).

Critical information: If in refrigerators Ariston Hotpoint s No Frost ice appears on the back wall freezer compartment, this almost always means failure defrost sensor (article C00368001). Replacing it will cost 1,500–2,500 rubles, but ignoring the problem will lead to breakdown of the compressor (repair from 8,000 rubles).

⚠️ Attention: Do not try to break off the ice with a knife or other sharp objects. This can damage the freon pipes, and repairs will cost half the cost of a new refrigerator.

5. Squeaking due to a malfunction of the compressor or control board

If the refrigerator Ariston squeaks intermittently (for example, every 5-10 minutes), and at the same time:

• 🔊 I can hear loud hum, but the engine does not start.
• 🌡️ The temperature in the chambers rises, and the food begins to deteriorate.
• ⚡ The display flashes F1 or E6.

are signs of problems with compressor or control board.

Here's how to diagnose the problem:

1. Checking the compressor:
   • Turn off the refrigerator and wait 10 minutes.
   • Turn it back on and listen: if the compressor buzzes, but does not start (no vibration), the start relay is probably burned out.
   • If the compressor is does not show any signs of lifethe winding may be broken.

Checking the control board:

• Inspect the board for darkened or swollen capacitors.
• Check the fuse (usually located next to the compressor). If it burns out, replace it with a similar one (the rating is indicated on the case).

To replace the compressor or board, it is better to call a specialist, since special equipment is required (vacuum pump, freon cylinder). However, if the problem is start relay, you can replace it yourself:

1. Disconnect the refrigerator from the network.
2. Remove the back cover (unscrew 4-6 screws).
3. Find the relay - this is a small box attached to the compressor.
4. Disconnect the wires (take a photo of their location!) and install a new relay (article number for Ariston: 481241820810).

⚠️ Attention: Parts of the compressor and control board may vary depending on the year of manufacture of the refrigerator. Check the article numbers in the documentation or on the manufacturer's website.

How to check a compressor with a multimeter

Connect the probes to the compressor terminals (after disconnecting the wires), the resistance between the contacts should be:

• C–S: 2–5 Ohms (working). winding),
• C–R: 10–20 Ohm (start winding),
• S–R: the sum of the two previous values.

If at least one value is 0 or infinity, the compressor is faulty.

6. installation

If the refrigerator Ariston started to squeak immediately after delivery or rearrangements, the reasons may be the following:

• 🚛 The position is brokenThe refrigerator should be standing strictly level (permissible slope - no more than 2°). If it is tilted, the door may not fit tightly.
• ⏳ The time interval is not maintainedAfter transportation, the refrigerator must be left alone for 4-6 hours (to stabilize the oil in the air). compressor).
• ⚡ Problems with the power supply. Perhaps there is insufficient voltage in the new outlet (there should be 220–240 V).

What do:

1. Check the level of the refrigerator with a building level. Adjust the height of the legs.
2. Make sure that there is enough space around the refrigerator for ventilation (at least 5 cm at the back and on the sides).
3. Connect the refrigerator to another outlet (preferably with grounding) If the squeaking stops, there is a problem. electrical wiring.

If the refrigerator squeaks and does not turn on after transportation, the contact in the start relay may have become loose or the freon tube is damaged. In this case, diagnostics are required at the service center.

7. When to call a technician: 5 signs of a serious breakdown

Not all problems can be solved on your own. Here direct indications for calling a specialist:

• 🔥 The compressor does not starteven though the relay clicks.
• ❄️ Ice forms again after 1-2 days after defrosting.
• 💥 A burning smell has appeared or smoke from under the refrigerator.
• 📛 On the display lights up F1 or E6, and resetting does not help.
• 🔌 The refrigerator gives an electric shock when touching the body.

Cost of repairs in service centers Ariston (for 2026):

Type of repair	Cost (₽)
Replacement of temperature sensor	1 500–2 500
Replacement of defrost heating element	2 000–3 500
Repair of control board	3 000–6 000
Replacement compressor	8 000–12 000

Before the technician’s visit:

1. Write down the model of the refrigerator (located on a sticker inside the chamber or on the back).
2. Take a photo of the error code on the display (if any).
3. Prepare a purchase receipt (if the refrigerator is warranty).

⚠️ Attention: The warranty on refrigerators Ariston is valid for 1-2 years (depending on the model). If your refrigerator was purchased less than 12 months ago, repairs should be free. Check the conditions in your warranty card.

FAQ: Frequently asked questions about the squeaking sound of the Ariston refrigerator

❓ The Ariston refrigerator squeaks, but the door is closed. What to do?

First check the sealing rubber - it could be dirty or dirty. deform. Wipe it with soapy water and lubricate it with silicone grease. If the squeaking continues, check the temperature sensor (section 2).

❓ Why does the Ariston refrigerator beep at night?

The defrost mode is probably triggered, but due to a malfunction of the sensor or heating element, the process is delayed. Defrost the refrigerator for 12 hours. and check the drainage hole. If the problem persists, replace the defrost sensor.

❓ E1 lights up on the display. How to reset the error?

Disconnect the refrigerator from the power supply for 10 minutes. If the error returns, check the refrigerator temperature sensor (section 2). In 90% of cases, it needs to be replaced.

❓ The Ariston refrigerator beeps and does not freeze. What is broken?

This is a sign of a compressor malfunction or a freon leak. You cannot fix the problem yourself - diagnostics are required at a service center. Do not turn on the refrigerator so as not to aggravate the breakdown.

❓ Is it possible to turn off the beeper? in the Ariston refrigerator?

Technically yes, but it is not recommended. The sound signal warns of malfunctions that can lead to food spoilage or breakage. If the squeak is annoying, eliminate its cause (see sections above).