Does your refrigerator hum around the clock, does not turn off and heats the kitchen like a battery? This is not just an annoying noise - it is a signal of a serious malfunction that can lead to equipment breakdown or food spoilage. Normally, the compressor should turn off for 10–20 minutes every hour, but if it works Indesit buzzes around the clock, doesn’t turn off and heats up the kitchen like a radiator? This is not just an annoying noise - it is a signal of a serious malfunction that can lead to equipment breakdown or food spoilage. Normally the compressor should turn off for 10–20 minutes every hour, but if it is running continuously for a day or longerthe problem cannot be ignored.
In this article we will analyze all possible reasons - from banal wear of the seal to complex breakdowns of the control board. You will learn how to independently diagnose a malfunction, when you can get by with adjusting the temperature, and when you urgently need a repairman. And also - why in 80% of cases it is not the compressor itself that is to blame, but the sensors or freon leak, and how to check this without disassembling the refrigerator.
1. Overload of products: when the refrigerator “chokes”
The most common reason for continuous operation is air exchange disturbance due to improper loading. If you have filled the freezer to capacity or placed hot pots in the main compartment, the compressor will try to compensate for the heat load, working without pauses.
This is especially dangerous for models Indesit with a system No Frost - the blowing fan is simply not will cope with air circulation if food blocks the grates. Check:
- 🥩 Freezer: whether it is filled to capacity (there should be 20% free space for circulation)
- 🍲 Main compartment: whether there are hot dishes (even warm pizza can increase the temperature by 5-7°C)
- 🧊 Door: are the shelves on the door overloaded (this breaks the seal)
How to check: unload the refrigerator by 30-40%, leave it empty for 2-3 hours. If the compressor starts to shut down, the problem is overload. If not, we look for a deeper reason.
2. Wear or damage to the door seal
The sealing rubber loses its elasticity over time, cracks or moves away from the body. Even a micro gap of 1-2 mm leads to constant flow of warm air, and the refrigerator tries to compensate for this by continuous operation. This is especially true for models Indesit BIAA 13, Indesit DF 4180 and others with a vertical handle - here the rubber wears out faster due to uneven fit.
How to diagnose:
- Take a sheet of paper A4.
- Close the door, holding the sheet between the seal and the body.
- Pull the sheet towards you - if it slips out without effort, the tightness is broken.
Check seal around the entire perimeter, paying attention to the corners (gaps most often form there). If the rubber is cracked or deformed, it needs to be replaced. For models Indesit original seals are suitable C00198766 (for single-chamber) and C00236713 (for double-chamber).
How to temporarily eliminate the gap without replacing the seal?
If the gaps are small (up to 2 mm), you can use silicone grease for rubber (for example WD-40 Specialist). Apply a thin layer of it to the seal, then heat the rubber with a hairdryer (temperature 50–60°C) and press the door for 10–15 minutes. This will restore elasticity for 2-3 months, but will not replace a complete replacement.
3. Malfunction of the thermostat or temperature sensor
The thermostat (or electronic sensor in modern models) is responsible for temperature control sending a signal to the compressor to turn on/off. If it breaks, the compressor either does not receive a command to stop, or receives false data about “overheating”. As a result - continuous operation until the motor is completely worn out.
Signs of thermostat failure:
- 🔄 The refrigerator does not respond to manual temperature changes (buttons or a regulator).
- ❄️ In the freezer, a thickness of more than 5 mm is formed snow "coat" (even in models with
No Frost). - 📉 The display shows an incorrect temperature (for example, -30°C in the freezer at real -10°C).
How to check the thermostat with a multimeter:
- Unplug the refrigerator, remove the back cover (in single-chamber models, the thermostat is located next to the compressor).
- Disconnect the wires from the thermostat, remembering them location.
- Switch the multimeter to resistance test mode (200 Ohm).
- At room temperature, the resistance should be 0 Ohm (contacts closed). Place the sensor in ice - the resistance should increase to infinity (open contacts).
Disconnect the refrigerator from the mains|Remove the back panel|Disconnect the wires from the thermostat|Check the resistance with a multimeter|Compare the readings with the norm (0 Ohm / ∞)-->
If the thermostat is faulty, it needs to be replaced. For models Indesit thermostats are suitable (for mechanical control) or sensors K59-L1937 (for mechanical control) or sensors NTC 10K (for electronic). The cost of the spare part is from 800 to 2500 rubles, depending on the model.
4. does not freeze, but works without stopping
Freon is a refrigerant that circulates through the system and removes heat. If it occurs leakage (for example, due to corrosion of pipes or mechanical damage), the compressor will run idle, trying to bring in cold, but to no avail. to overheating and failure of the compressor.
Signs of a freon leak:
- 🔥 The compressor is hot to the touch (temperature above 70°C).
- ❄️ The freezer is warmer than it should be (for example, -5°C instead of -18°C).
- 💧 oil appears on the back wall of the refrigerator (freon mixed with compressor oil).
- 🔊 The compressor operates louder than usual, clicks or knocks are possible clicking or knocking noises.
It is impossible to eliminate the leak on your own - it is necessary to soldering of pipesevacuate the system and refill with new freon at service centers for Indesit use freon R-134a (for models before 2018) or R-600a (for new environmentally friendly refrigerators). The cost of repairs is from 3,500 to 6,000 rubles.
Up to 2010|2010–2015|2016–2020|2021–2023|I don’t know-->
⚠️ Attention: If you suspect a freon leak do not turn on the refrigerator after shutdown, this can lead to the compressor jamming. It is better to immediately call a technician for diagnosis.
5. Compressor failure: when the motor runs but does not cool
The compressor is the “heart” of the refrigerator, and its malfunction often manifests itself. continuous operation without shutdownsmay be different:
- 🔋 Interturn short circuit in the winding (the compressor hums, but does not create pressure).
- 🛢️ Wear of the piston group (the motor works, but does not pump freon).
- 🔥 Overheating due to a faulty start-up relay.
How diagnose:
- Turn off the refrigerator, wait until the compressor cools down (1-2 hours).
- Turn it on again and listen:
- ✅ Norm: the compressor starts with a slight click, after 5-10 seconds a uniform hum begins.
- ❌ Failure: motor clicksbut does not start, or works with extraneous knocks.
If the compressor is faulty, it needs to be replaced. For Indesit motors are suitable Embraco EGX 90 (for low-power models) or Secop (Danfoss) NL 11 (for refrigerators with a capacity of 200+ liters). The cost of a new compressor is from 5,000 to 12,000 rubles, plus 2,000–3,000 for the work of a technician.
| Refrigerator model | Compressor type | Signs of malfunction | Replacement cost (rub) |
|---|---|---|---|
| Indesit BIAA 13 | Embraco EGX 90 | Clicks, but does not start | 6 000–8 000 |
| Indesit DF 5200 | Secop NL 11 | Works without stopping, does not freeze | 8 000–10 000 |
| Indesit C 132 G | Matsushita CNV 10 | Overheats, turns off after 5 minutes | 7 000–9 000 |
6. Control board failure: when the “brain” of the refrigerator gives incorrect commands
In modern models Indesit (for example, Indesit ITF 118 or Indesit EWD 8140) the electronic control board is responsible for the operation of the compressor. If it fails, the compressor may receive false signals the need for continuous cooling.
Signs of a board malfunction:
- 📱 Flashing on the display errors (for example,
F05,F07orE01). - 🔄 Refrigerator spontaneously reboots (relay clicks, short-term shutdown).
- 🎛️ Does not respond to button presses or resets settings.
What to do:
- Unplug the refrigerator for 10-15 minutes (sometimes “rebooting” helps).
- Check the voltage in the network - the board may fail due to voltage surges (norm: 220V ±10%).
- If the error remains, it is required reflashing or replacing the board. data-i="197">the original board costs 4000–7000 rubles. Indesit the original board costs 4,000–7,000 rubles.
⚠️ Attention: If the refrigerator is under warranty, do not open the board yourself this will void the warranty. Contact the service center Indesit with a receipt and passport. products.
7. External factors: why the refrigerator is not to blame
Sometimes the problem lies not in the refrigerator itself, but in conditions of its operation. Check:
- 🌡️ Room temperature: if the kitchen is hotter than +30°C, the compressor physically cannot turn off (normal: +16...+25°C).
- ☀️ Direct sunlight: if the refrigerator is located near the window, its body heats up and the sensors are triggered more often.
- 🔌 Network voltage: with low voltage (less than 200V), the compressor wears out, not having time to gain the required power.
Solutions:
- Install voltage stabilizer (for example, Resanta ACH-1000/1-C).
- Move the refrigerator away from stoves, radiators or windows (minimum distance - 50 cm).
- Check ventilation grilles on the back wall - they should not be clogged with dust.
What to do if the Indesit refrigerator does not turn off: step-by-step instructions
Algorithm of actions for self-diagnosis:
Disconnect the refrigerator from the network for 1 hour|Check the door seal with a sheet of paper|Unload the freezer and the main compartment|Measure the temperature in the room|Check the voltage in the outlet with a multimeter|Listen to the compressor for extraneous sounds-->
If after all the checks the problem remains, call a technician. The average cost of diagnostics is 1500–2000 rubles. In 60% of cases, repairs are cheaper than buying a new refrigerator (with the exception of compressor failure in models older than 10 years).
⚠️ Attention: If a refrigerator Indesit with a system No Frost works without stopping and at the same time ice forms in the freezerit is most likely broken defrost heater or timer. In this case, do not try to defrost the refrigerator forcibly - this may damage the evaporator.
FAQ: Frequently asked questions about the continuous operation of the Indesit refrigerator
Is it possible to use the refrigerator if it does not turn off?
Short-term (1-2 days) - yes, but this is fraught compressor overheating and an increase in energy consumption by 30-50%. If the problem is not solved within a day, it is better to turn off the refrigerator and transfer it. food in a cooler bag or to your neighbors.
How much does it cost to repair if the Indesit refrigerator works without stopping?
The cost depends on the reason:
- Replacement of the seal: 1500–2500 rub.
- Thermostat repair: 2000–3500 rub.
- Freon refilling: 3500–6000 rub.
- Replacement of the compressor: 7000–12,000 rub.
In regions, prices may differ by 15–20%.
What is the service life of the Indesit compressor?
On average - 10–15 years if the refrigerator is older than 12 years and the compressor is faulty, it is more economical to buy a new model than to buy a new model. repair the old one (the cost of spare parts can exceed 50% of the price of a new refrigerator).
Can the refrigerator work without stopping due to a dirty condenser?
Yes, if condenser grill (on the back wall) is clogged dust or wool, heat exchange is disrupted and the compressor is forced to work longer. Clean the grill with a vacuum cleaner or brush (at least 2 times a year).
What to do if the Indesit refrigerator is new, but does not turn off?
Probably this defect or incorrect installation. Check:
- Is there a gap between the refrigerator and the wall? 5 cm between the refrigerator and the wall.
- Is the door warped (check with a level).
- Are there any shipping bolts on the compressor (they must be removed!).
If everything is in order, contact the store for a replacement under warranty (period is 12 months from the date of purchase).