Have you opened the freezer Indesitand there, instead of the expected icy cold, warmth and puddles? Or does the engine hum, but the temperature does not drop below +5°C? Problems with the freezer are one of the most common problems with refrigerators of this brand. In 60% of cases, it is not breakdowns that are to blame, but operating errors or minor malfunctions that can be fixed without a technician.
In this article, we will look all possible reasonswhy the freezer in the refrigerator Indesit stopped working: from banal icing to serious compressor breakdowns. You'll learn how to diagnose a problem based on its "symptoms," what to check first, and when repairs are actually needed. And also - step-by-step instructions for troubleshooting yourself (with photos and diagrams).
⚠️ Important: if your refrigerator is under warranty, do not disassemble it yourself! Opening the seals will void the warranty Indesit. First, check the documentation or contact the service center.
1. The freezer does not freeze, but the refrigerator compartment is working: top 3 reasons
If the main chamber cools food normally, and the freezer is “resting,” the problem lies in one of three systems:
- 🔌 Malfunction of the freezer thermostat —the sensor has stopped sending a signal to the compressor about the need for cooling. Most often it breaks down in models Indesit C 132 G i Indesit ITF 118 after 5-7 years of operation.
- ❄️ Clogged drainage system —ice blocks the circulation of refrigerant between the chambers. Typical for refrigerators with a system
No Frost. - 🔄 Failure of the switching valve —in two-compressor models the valve “sticks” and does not switch the cold to the freezer.
How to check? Unplug the refrigerator for 10 minutes, then turn it on again. If the freezer starts working, the problem is temporary failure of electronics (possibly after a power surge). If not, read on.
2. The freezer works, but does not freeze: check the seal and door
One of the most common reasons is tightness failure. If the sealing rubber is worn out or the door does not close tightly, warm air enters the chamber and the temperature rises. How to diagnose:
- Close the door and try to stretch a piece of paper between it and the body. If it passes easily the seal is worn out.
- Shine a flashlight inside the closed freezer. If light is visible, there are gaps.
- Check the hinges: over time they sag and the door warps.
In models Indesit s No Frost (for example, Indesit DF 5200 W) the seal often loses its elasticity due to temperature changes. It can be restored:
- 🧴 Lubricate the rubber with silicone grease (not Vaseline!).
- 🔥 Warm it up with a hairdryer at minimum power (hold at a distance of 20 cm).
- 🔄 Re-weigh the door to the other side (if the model supports reverse).
3. The compressor works, but the freezer does not cool: is freon to blame?
If the motor is humming, but the temperature in the freezer does not drop below +10°C, two problems are possible:
- Refrigerant (freon) leak —more often occurs in places where tubes are soldered or due to corrosion of the circuit. Typically for refrigerators older than 8 years.
- Clogged capillary tube —small particles of oil or moisture block the circulation of freon. In this case, the compressor runs “idle.”
How to understand that freon is to blame?
- 🔊 The compressor works without stopping, but does not turn off.
- 🌡️ Temperature in the freezer rises to +15...+20°C.
- 🔧 Oily stains are visible on the back wall of the refrigerator (a sign of leakage).
It is impossible to fix the leak yourself —special equipment is required for refilling freon. But you can check:
- 🔍 Inspect the circuit for corrosion (especially in places where the tubes are bent).
- 📏 Check if the capillary pipeline is bent (sometimes this happens during transportation).
What will happen if you ignore a freon leak?
If the leak is not eliminated, the compressor will wear out, which will lead to its breakdown in 3-6 months. The cost of replacing a compressor is up to 70% of the price of a new refrigerator.
4. Indesit freezer does not freeze after defrosting: what to do?
You defrosted the refrigerator, turned it on again, but the freezer does not work? The reasons may be different:
| Symptom | Possible cause | Solution |
|---|---|---|
| The freezer does not turn on at all | Thermal protection fuse has tripped | Turn off the refrigerator for 30 minutes, then turn it on again |
| The compressor hums, but does not freeze | Humidity has entered the electronic unit | Dry the refrigerator for 12-24 hours with the door open |
The display flashes an error F04 or F05 |
Temperature sensor malfunction | Check the sensor contacts (see section 6) |
| Ice on the back wall of the freezer | Clogged drainage hole | Clean the hole with wire or a syringe |
Critical error: if after defrosting the refrigerator Indesit makes clicks but does not start, immediately unplug it! This is a sign of a short circuit in the start relay.
5. Electronic faults: errors F02, F03, F07
Modern models Indesit (for example, Indesit BIAA 13 or Indesit ITF 116) are equipped with a self-diagnosis system. If error codes related to the freezer appear on the display, decipher them:
F02— malfunction of the freezer temperature sensor. What to do: check the sensor contacts (it is located behind the back wall of the freezer).F03—problem with evaporator sensor. What to do: defrost the refrigerator for 24 hours, then turn it on again.F07— a malfunction in the compressor control circuit. What to do: replacement of the electronic module is required.
How to reset the error:
- Unplug the refrigerator for 1 minute.
- Plug it back in and immediately press the button
Super Freeze(if any) for 5 seconds. - If the error remains, you need a diagnostic technician.
Check whether the freezer door is tightly closed
Turn off the refrigerator for 10 minutes and turn it on again
Look at the error code in the instructions for the model
Check the voltage in the outlet (should be 220-230V)-->
6. Mechanical breakdowns: compressor, fan, heating element
If the freezer does not work, but all sensors and electronics are in order, the problem may lie in the hardware:
- 🔧 Failure of the compressor —if it does not start or works intermittently, the freezer will not cool. Check: touch the compressor (it should vibrate). If it is hot, but does not vibrate, the winding has burned out.
- 🌀 Fan malfunction - in models with
No Frostthe fan distributes the cold. If it is broken, the freezer will freeze poorly. Check: when the door is open, you should hear the noise of the blades. - 🔥 Failure of the defrost heating element —if the ice does not melt during automatic defrosting, it blocks the operation of the system. Check: turn off the refrigerator and inspect the evaporator for ice.
⚠️ Attention: if the compressor Indesit makes loud knocking or rattling noises, immediately turn off the refrigerator! This is a sign of mechanical destruction internal parts. Further work will lead to oil leakage and complete failure.
7. Prevention: how to avoid freezer breakdowns
To ensure that the freezer in the refrigerator Indesit works without failures, follow simple rules:
- ❄️ Defrost the refrigerator at least once every 6 months (even if the model is with
No Frost). - 📦 Do not overload the freezer with food - leave gaps for air circulation.
- 🔌 Use voltage stabilizer - network surges most often damage electronic boards.
- 🧊 Do not put hot foods in the freezer - this leads to icing of the evaporator.
FAQ: Frequently asked questions about the Indesit freezer not working
The Indesit freezer does not freeze, but the light inside is on?
Most likely, faulty thermostat or compressor data-i="186">After moving, the Indesit refrigerator turned on, but the freezer does not work. What should I do?. The light is on because the light is supplied separately from the cooling system. Check if you can hear the compressor noise. If not, call a technician.
After moving, the Indesit refrigerator turned on, but the freezer did not work. What to do?
Probably, during transportation the capillary pipeline is damaged the compressor contacts came loose. Turn off the refrigerator for 12 hours (so that the oil flows into the compressor), then turn it on again. diagnostics.
The Indesit freezer is covered with ice, but does not freeze. Why?
This is a sign clogging of the drainage system or malfunction of the defrosting heating element. 24 hours, then clean the drainage hole (it is located under the freezer drawers).
An error is blinking on the display F01The freezer does not work. is this?
The error F01 means there is a problem with the refrigerator temperature sensor. cameras. But sometimes it appears when the freezer breaks down. Try resetting the error (turn off the refrigerator for 5 minutes), if that doesn’t help, check the sensor contacts.
How much does it cost to repair an Indesit freezer?
The cost depends on the breakdown:
- Replacing the seal - 1,500–3,000 ₽.
- Refilling freon - 3 500–6,000 ₽.
- Repair of the electronic unit - 4,000–8,000 ₽.
- Replacement of the compressor - 7,000–12,000 ₽.
⚠️ Attention: if the refrigerator is more than 10 years old, repairs may be unprofitable. Compare the cost with the price of a new one Indesit of a similar model.