Trade brand refrigerators Indesit are deservedly popular due to their reliability and affordable price, but over time, even the highest quality equipment requires maintenance. One of the first signs of wear is a loose chamber seal, often caused by damage or loss of elasticity of the magnetic seal. If you notice that the door has begun to not fit tightly, and an ice coating has begun to form inside the unit, then it’s time to think about replacing the sealing rubber.
Ignoring this problem can lead to serious consequences, including failure of the compressor due to continuous operation and increased energy consumption. In this article we will analyze in detail the process of selecting, dismantling the old and installing a new seal, paying attention to the nuances that are specific to the equipment of this Italian brand. A properly performed replacement can extend the life of your refrigerator for many years.
⚠️ Attention: Before starting any disassembly or replacement of parts, be sure to disconnect the refrigerator from the electrical outlet. Working with electrical appliances under voltage is strictly prohibited and dangerous to life.
Restoring tightness is not only a matter of saving electricity, but also guaranteeing the safety of your products. Violation of the temperature regime inside the chamber can lead to rapid spoilage of food and the growth of bacteria. Therefore, it is important not to delay repairs if you find that the door Indesit refrigerator no longer closes tightly or the magnetic tape no longer holds the door in the closed position.
How to understand that the seal requires replacement
Determine wear magnetic tape can be examined visually and using simple tests that do not require complex equipment. Users often notice a problem when a “coat” of frost appears on the back wall of the refrigerator or freezer, although this has not been observed before. This is a sure sign that warm, moist air gets inside the chamber, which, condensing, freezes on the evaporator.
Another diagnostic method is the so-called test with a sheet of paper. Take a regular A4 sheet, open the door slightly and insert the paper between the seal and the body, then slam the door. Try to pull out the sheet:
- 📉 If the paper is difficult to remove and strong friction is felt, the tightness is normal.
- 📉 If the sheet slides freely or falls out, it means sealing rubber it does not fit tightly in this place.
- 📉 If the paper is easily removed in several places around the perimeter, a complete replacement of the circuit is required.
Also pay attention to the appearance of the rubber itself. There should be no cracks, creases, tears or traces of mold that is difficult to remove. If the rubber has become hard and lost its elasticity, it will not be able to provide the necessary fit, even if it visually appears intact. In such cases restoration will no longer help, and the only way out will be to install a new part.
Selecting a suitable seal for the Indesit model
Selecting the right spare part is a critically important step, since there are no universal solutions for all models. Refrigerators Indesit are produced in various modifications, and the geometry of the seal profile can differ significantly even within the same model range. Incorrectly selected rubber will not fit into the groove or will allow air to pass through, which will reduce all your efforts to zero.
To find the right part, you need to know the exact model number of your refrigerator. It is usually indicated on a sticker located inside the refrigerator compartment on the side wall or on the rear panel of the cabinet. Look for a code that starts with letters, for example Indesit C 130 or Indesit SB 185. It is this code that should be used when searching for spare parts in supplier catalogs or specialized stores.
When ordering, pay attention to the following parameters:
- 🔍 Type of fastening: in modern models, rubber is often inserted into a special groove, in older ones it can be attached with glue or screws.
- 🔍 Material: high-quality seals are made of frost-resistant rubber that does not harden at low temperatures.
- 🔍 The presence of a magnetic insert: make sure that there is a solid magnetic tape running inside the profile.